Judi Jaksa Custom Digitizer

Card Invitation 2Designs -- Set of 8

** Use Mylar in:

the Rose in JJ09,

the gold star tail in JJ12,

JJ09 Invitation- Come to a Party-Cake **Add a layer of Mylar under the Rose -- 4.00 by 5.17 inches with 5156 stitches

JJ10 Invitation -- You Are Invited - December -- 4.00 by 5.50 inches with 4947 stitches

JJ11 Invitation -- You're Invited to a Birthday Party (circular) -- 3.97 by 5.22 inches with 3680 stitches

JJ12 Invitation -- It's A Party Stars -- 3.96 by 4.57 inches with 4346 stitches

JJ13 Invitation- It's A Barbeque -- 4.05 by 5.69 inches with 4205 stitches

JJ14 Invitation -- You're Invited to a Party (curved all at top) Balloons filled -- 3.86 by 5.33 inches with 3707 stitches
JJ15 Invitation -- You're Invited to a Birthday Party (straight all at top) -- 3.85 by 5.00 inches with 3810 stitches

JJ16 Invitation -- It's A Party Cocktails -- 4.19 by 4.35 inches with 2783 stitches

Note: I have included a party invitation Word document " Invitation Message" with each purchase
that you can use for vertical and horizontal printing inside the card before you embroider the
outside of the card.

It fits 2 sizes--the 10.5 by 6.5 card & 6.5 by 10.5inches.

The document is not locked so you can changed
the custom size to fit your card size if it is larger/smaller.

The card stock was purchased from the local Michael's craft shop in a package of 40 blank folding cards (with envelopes) sized at 6.5 by 5 inches folded for under $10. The store also has a Value pack of 25 envelopes and 25 folding cards--5 1/2 x 4inch cards for $6. Both packages state "Heavy card stock".

Card Making Instruction Steps:

1. Hoop a cutaway stabilizer & spray top with Spray adhesive & Use a Sharp #10 needle

2. Find & mark with a light pencil dot the center front of the card

3. Lay the card (wrong side down) on top of stabilizer-centering the the design & center of the card

4. Hold card down firmly in place, start machine off very slowly to 2nd stitch and proceed slowly

5. Make sure that the card stays flat on the stabilizer or the stitches will go through.

6. When the design is complete, trim 3 sides stabilizer, and glue the trimmed 4th side to cover the stitches.

Have fun adding your own personal messages to the inside of each individual card!

Do you have the Pfaff 150 x 150 All Fabric Hoops?

This card fits perfectly in that hoop for the 5inch designs.

Return

Judi Jaksa Custom Digitizer www.customdigitizer.com